The new feature "reglap" allows two sizes of floating-point register
variables (reg_float), if each register overlaps a single register of
the other size. PowerPC ncg uses reglap to define 4-byte instances
of f14 to f31 that overlap the 8-byte instances.
When ncgg sees the definition of fs14("f14")=f14, it removes the
8-byte f14 from its rvnumbers array, and adds the 4-byte fs14 in its
place. Later, when ncg puts a variable in fs14, if it is an 8-byte
variable, then ncg switches to the 8-byte f14. The code has
/* reglap */ comments in util/ncgg or #ifdef REGLAP in mach/proto/ncg
reglap became necessary because my commit a20b87c caused PowerPC ego
to allocate reg_float in both 4-byte and 8-byte sizes.
After c5bb3be, ncg began to allocate regvars from r13 up. I reorder
the regvars so ncg again allocates them from r31 down. I also reorder
the other registers.
This exposed a bug in my rule for ret 8. It was wrong if item %2 was
in r3, because I moved %1 to r3 before %2 to r4. Fix it by adding
back an individual register class for r3 (called REG3 here, GPR3 in
c5bb3be).
Also fix my typo in mach.c that made a syntax error in assembly.
Use f14 to f31 as register variables for 8-byte double-precison.
There are no regvars for 4-byte double precision, because all
regvar(reg_float) must have the same size. I expect more programs to
prefer 8-byte double precision.
Teach mach/powerpc/ncg/mach.c to emit stfd and lfd instructions to
save and restore 8-byte regvars. Delay emitting the function prolog
until f_regsave(), so we can use one addi to make stack space for both
local vars and saved registers. Be more careful with types in mach.c;
don't assume that int and long and full are the same.
In ncg table, add f14 to f31 as register variables, and some rules to
use them. Add rules to put the result of fadd, fsub, fmul, fdiv, fneg
in a regvar. Without such rules, the result would go in a scratch
FREG, and we would need fmr to move it to the regvar. Also add a rule
for pat sdl inreg($1)==reg_float with STACK, so we can unstack the
value directly into the regvar, again without a scratch FREG and fmr.
Edit util/ego/descr/powerpc.descr to tell ego about the new float
regvars. This might not be working right; ego usually decides against
using any float regvars, so ack -O1 (not running ego) uses the
regvars, but ack -O4 (running ego) doesn't use the regvars.
Beware that ack -mosxppc runs ego using powerpc.descr but -mlinuxppc
and -mqemuppc run ego without a config file (since 8ef7c31). I am
testing powerpc.descr with a local edit to plat/linuxppc/descr to run
ego with powerpc.descr there, but I did not commit my local edit.
